Worcester Si Mk II Manuel d'instructions télécharger pdf (Page 22)

Clips

Cover panel

Screw

Tab

Blanking

plate

Tab

Cover panel

Clips

Screw

Programmer

DANGER: 230 VOLTS

DO NOT TOUCH THE ELECTRICAL

COMPONENTS OR CIRCUITS

CAUTION:

ISOLATE THE MAINS ELECTRICITY

SUPPLY BEFORE STARTING ANY WORK

OBSERVE ALL RELEVANT SAFETY

PRECAUTIONS

OBSERVE ELECTRO-STATIC

DISCHARGE PRECAUTIONS:

DO NOT TOUCH THE PCB CIRCUIT

5. Align the connector plug pins into socket on the

PCB and push fully home.

6. Feed the ribbon cable into the recess.

7. Align the programmer and locate the clips, push

into the slots then down to secure.

8. Locate the cover panel in place and secure with

the screw.

9. Replace fascia cover and outer casing before

switching on the electrical supply and boiler.

Switch boiler on when completed.

Refer to the User Instructions section for details

of pre-set and setting programs.

DT20RF RECEIVER

INSTALLATION

1. Remove the boiler outer casing and control

panel fascia to gain access to the heatronic

control panel.

2. Release the securing screws.

3. Pull the cover panel up to remove.

4. Grip the tab and pull upwards to disengage

clips, pull forward to remove blanking plate or

existing programmer.

Recess

Programmer

Ribbon

cable

Connector plug

NOTE: THIS ACCESSORY MUST BE FITTED

BY A COMPETENT PERSON.

FAILURE TO COMPLY COULD LEAD TO

PROSECUTION.

OPERATING & INSTALLATION

INSTRUCTIONS

DT20RF PROGRAMMER

INSTRUCTION MANUAL

8 716 115 495a (02.2009)

8_716_115_495a 9/2/09 11:49 Page 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Worcester Si Mk II Manuel d'instructions Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Thermostats Worcester Si Mk II