Worcester Si Mk II Manuel d'instructions télécharger pdf (Page 30)

DIGISTAT

INSTALLATION

DIGISTAT / DT10RF RECEIVER

TO CHECK PREVIOUSLY

INSTALLED UNIT

3. Replace the front cover by locating in position and

pushing fully onto the back cover.

To check signal strength on previously

installed and paired units :

1. Press the ‘set’ button 4 times.

2. Press ‘OK’ once.

3. Press the ‘set’ button 5 times. The display will

show ‘SSI and OFF’.

4. Press the ‘+’ button so that the display shows

‘SSI, Antenna and ON’.

5. Press the ‘set’ button so the display shows ‘SSI

and Antenna’.

6. After a few seconds the display will show ‘---’.

7. Remove the batteries from the transmitter and wait

until the display has faded away.

8. Press and hold the ‘+’ button on the transmitter

while re-inserting the batteries and keep the

button depressed until the display shows ‘rF’ .

OPERATING & INSTALLATION

INSTRUCTIONS

DT10RF PROGRAMMER

INSTRUCTION MANUAL

8 716 115 493a (02.2009)

8_716_115_493a 9/2/09 09:46 Page 30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Worcester Si Mk II Manuel d'instructions Page 30